This keyless garage door opener entry pad works with Genie transmitters using 390 MHz frequency. It is NOT compatible with Genie Intellicode transmitters. The Door Code in the Step-By-Step Procedure at right is determined by the internal code switches inside your transmitter and the accompanying chart. Determine the settings of the first 3 switches and write down the corresponding number from the chart. Continue with the next 3 switches and its corresponding number, and so on, until the last set of 3 switches. You should have 3 or 4 Door Code numbers.

Door Code in Step 4: ___ ___ ___ ___

Step-By-Step Procedure

1. Reset Keypad--slide keypad cover half way up. While pressing the # and 8 buttons simultaneously, slide the Keypad Cover the rest of the way up until it latches. Release # and 8 buttons. At this point, if the back lit keypad light stays on, proceed directly to step 2. If the back lit keypad light goes out, close the cover pad and reopen it until it clicks. Proceed to step 2.
2. Press 3, 5, 7 and # buttons in said order.
3. Enter your PIN and press the # button. Your PIN number can be created from any group of numbers up to 8 digits of your choice. Note: Do NOT use"#" or "star" key.
4. Enter Door Code, as determined from the chart at left, and press the "star" key.
5. Slide Keypad Cover down.
6. Test Keypad by sliding cover up until it latches. Enter your PIN and Press "star" key. Your door should operate.